Hansen Fast-Flo Trough / Tank Valve Short Arm Pack

Features Each valve is supplied with: Complete Plastic Valve Body, Brass Arm & Long Tail Adaptors performance, cost effective trough/tank valve - 29 psi, 34 l/min Fast~Flo Short Arm Valve has the highest flow of any valve of its size at 500 kPa (73 psi) it will deliver 56 l/min Ability to attach a diffuser hose to reduce water turbulence & noise in top entry installations & Anti-Syphon Holes to prevent back flow Designed with an Ezi Bend brass arm to make water level adjustment a breeze Will fit multiple thread & connection combinations 15 - 50mm Reliable with high and low pressure applications from 0.2 - 12 bar Durable urethane seat, which is reversible Suitable for top or side entry Manufactured from strong non corrosive UV stabilised materials     Thread is 5/16" 7.95mm Overview The Hansen Fast Flo Valve is ideally suited to tight fitting environments that demand a more compact sized valve with responsive on / off capabilities, exceptional flow rates and adaptability. The Fast Flo allows a hose attachment to both diffuse and help eliminate noise from the outlet flow and has a tough, reversible, urethane seat which effectively doubles the life of the valve providing a 'best of class' valve that's reliable for the long term. Trough / Tank Installation: Flush pipelines into a water tank or troughs before installing Fast~Flo Valve into new system Isolate the water going to the trough or tank to replace a valve in an existing system. Thread O-Ring end of correct size Long Tail Adaptor into Fast~Flo Valve Body and tighten firmly enough that the O-Ring creates a seal against the Fast~Flo Valve Body face. Do not overtighten. TO CHANGE WATER LEVEL Adjust the length of cord at top of float. Use the nut & cord on the long arm valve only. Side Entry Trough/Tank: Place the ribbed side of the Rubber (soft) Washer against the hole inside the trough/tank. Insert the Long Tail Adaptor through the washer & inlet hole in the trough/tank wall. On the outside, place the Poly (hard) Washer on the Long Tail Adaptor with the ribs facing the trough/tank wall. Thread on Adaptor Nut and tighten firmly. Do not overtighten. Screw the Cord Nut* onto the Fast~Flo Brass arm. Thread the Cord* through the Fast~Flo Float. Tie the Cord off to achieve the correct water level. *Cord and Nuts only supplied with long arm version. NOTE: If there is an existing or moulded threaded inlet in the trough or tank use a Hansen Standard Adaptor. Top Entry Trough/Tank Place the ribbed side of the Rubber (soft) Washer against the hole inside the trough/tank. Insert the Long Tail Adaptor through the washer & inlet hole in the trough/tank wall. On the outside, place the Poly (hard) Washer on the Long Tail Adaptor with the ribs facing the trough/tank wall. Thread on Adaptor Nut and tighten firmly. Do not overtighten. Screw the Fast~Flo Float on to the Brass Arm, do not bend Brass Arm